SOHC.co.uk Forums > Project Board
75 CB400 "Dad's old bike" project
Pops400:
;D
I just keep plugging away until I get a day when lots of progress happens, that gives me enough lift to take me through a few more crap ones.
Trigger:
--- Quote from: Pops400 on November 14, 2016, 06:22:48 AM --- ;D
I just keep plugging away until I get a day when lots of progress happens, that gives me enough lift to take me through a few more crap ones.
--- End quote ---
Just focus on the frame and engine. Once this is done, everything else just basically bolts on.
Pops400:
Frame is looking like quite a problem, but the engine I'm flummoxed by what to do. It did actually turn over and sounded OK, albeit briefly. Semi-tempted to try and clean it up without pulling it apart, but kind of know that's asking for trouble.
Kind of know that pulling it apart is asking for trouble too, though. And probably a load of money I don't have. :o ::)
mike the bike:
Instead of going down the clip ons route, have you considered ace bars? Best of both in my opinion.
Pops400:
Hi Mike. Considering any and all at the moment. Happy to put the time into planning, so I know what I'm aiming at.
'scuse my ignorance, though, I thought Ace / Clubman were different terms for the same thing?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version