SOHC.co.uk Forums > CB500/550

Custom switches electrics

<< < (2/3) > >>

Bryanj:
The toggle would need to have two relays with the input power to the common and selected powers going to relay

Noelia:


--- Quote from: Bryanj on January 26, 2016, 06:17:52 AM ---The toggle would need to have two relays with the input power to the common and selected powers going to relay

--- End quote ---

Hi Bryanj,

I asked the Seller of the switches and he said that with one is enough for the toggles, I found some more info in another forum and found the below schematic set up, it is not the same that I need but similar, there is a toggle there and it only have one relay.

Now I'm doubting!!


Noelia

Noelia:
Also in the picture says "standard relay" and "switching relay" does someone knows the differences?


Noelia

hairygit:
Standard relay is just on/off, switching relay is on/on, but switches between 2 sets of contacts, for example high and low beam.

ST1100:

--- Quote from: hairygit on January 26, 2016, 07:47:08 PM ---...for example high and low beam.
--- End quote ---
For which one could also use a latching-relay...  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page