SOHC.co.uk Forums > CB750

Dry your bike for less!

<< < (3/3)

ST1100:

--- Quote from: Johnwebley on February 06, 2016, 06:36:27 PM ---how about this ??
http://www.screwfix.com/p/energer-2000w-heat-gun-240v/59740
--- End quote ---
I'm sure Julie melts for that one...  ;)

They've quite a low but seriously hot air-flow, risk of damaging plastic, cable sleeving and paint (or Julie's powder-coating...)

I use them for applying shrink tubes, to remove/installing bearings (instead of a blow-torch) or to soften those stubborn carb isolators...

MarkCR750:
Yes they are a great tool, I've freed of corroded bolts with them they get so hot, drying your bike with one would be a tad expensive though, respray, new plastic bits etc etc 😀

Navigation

[0] Message Index

[*] Previous page