SOHC.co.uk Forums > CB500/550
To do before start up attempt?
MaximoGF:
Hi guys
Just got myself a 1976 CB550 F Super Sport, imported from the States. Don't know the last time it was started, could be 20 years for all I know. I am hoping to cafe/brat it up a little but before I do i obviously need to get it going.
My thoughts? Carb clean, new spark plugs, fresh oil & filter, battery and fuel of course.
The ignition barrel looks like it needs changing plus I have no key anyway also there is no gear change lever.
I would appreciate anyone's thoughts and wether I am anywhere near the mark? I am a complete novice by the way.
Thanks in advance
ST1100:
Definitely valve and points adjustment.
Probably sticking advancer too.
hairygit:
New air filter is always a good idea. Also, after changing the oil and filter, leave the spark plugs out, and wind the engine over in the starter or kickstart until the oil light goes out, then put the plugs in and try starting it. Don't forget to have a good look at the debris in the old oil (strain it through an old sieve) it will give you clues as to anything drastically wrong inside, such as damaged gears etc. Good luck!
Sent from my X5 using Tapatalk
MaximoGF:
Air filter, good call forgot about that. About the points; do u think it's worth fitting an electronic ignition system from the off? Like the Dyna-s?
Chris400F:
My 400 hadn't been used too much before I got it. I took the sump off and there was a fair amount of accumulated sludge at the bottom, which may have stayed there or may have mixed with the fresh oil if I hadn't cleaned it all out.
Navigation
[0] Message Index
[#] Next page
Go to full version