SOHC.co.uk Forums > CB750

CB750F1 'o' rings.

<< < (3/3)

Spitfire:
Neither of the two gasket sets (F1 and F2) had all the "O" rings in them and both were from DS, I can' remember whether they were Honda or not as it was quite a few years ago.

Cheers

Dennis

adriangsmith:
I had the same issue recently.
Both oil control o rings and the stud o rings were missing from the DS kit.
DS ripped me off for £10 for 4 of the oil control o rings.
I bought the stud orings off ebay as they are now discontinued from honda.
Bit of a poor show when it states full engine gasket kit and the most common use is a top end strip down and these orings are missing.

Bryanj:
Its a long time since i used genuine sets but i seem to remember that if it is shown on the crankcase page its part of a bottom set, Honda NEVER sold complete sets

Skoti:
Yes I see what you mean, but it's a bit confusing when the cylinder base gasket is included in the kit but not the oil feed 'o' rings.

Anyway I've re-built the top end with new 'o' rings fitted to crankcase as well and all seems good.  :) 

Navigation

[0] Message Index

[*] Previous page