SOHC.co.uk Forums > CB750

CB750 K4 Installing outer clutch drum

<< < (2/3) > >>

royhall:
Thanks Trig, I expected the basket to go right back to the bearing and that shows it, must be the kick-start gear holding it off. It is very tight going on the splines though. Going to have another go now. Cheers.

Sent from my Nexus 6 using Tapatalk

royhall:
Thanks Trigger sorted it now.

It was the kickstart cog holding it off. Had to pull the shaft to the left to allow it to engage as it's a bit floppy until the outer casing is on and it was trapping behind the cage. Once I did that it tapped on with the mallet okay.

Another learning curve out of the way.

Cheers.

Trigger:
Job done Roy, Next ;D ;D

royhall:
I know, its been a rough few days. Wouldn't mind but its not even my engine, just helping out another forum member. Good job I dont do this for a living. ;D Thanks for the help.

MCTID:
Don't be so modest our Roy........I'm very grateful for all your help......and not only for your many mechanical skills, but also your slant on life and other stuff.

Despite our 'setbacks' on this project I would have no hesitation in doing it again...........easy for me to say I admit, but it's like Chris Tarrant says on Millionaire.......'It's only easy when you know the answers'.

Giving new life to a 40 year old motor is always fraught with obstacles, and it's a credit to your tenacity and a great advert for the support of members of the sohc Forum that we are nearly there.

Navigation

[0] Message Index

[#] Next page

[*] Previous page