SOHC.co.uk Forums > CB500/550

Tapered steering head bearing install

(1/2) > >>

sam_vfr:
Right then.  I'm in the process of rebuilding my cb550 and I'm just about ready to install the head bearings.  I have a set of bearing from All bearings and they come with 2 different thickness spacers.  I've read so many post of what thickness to use and where to install the spaces that I'm still none the wiser.  Unfortunately I don't have the old races that I can measure and compare.  Is there another way of measuring this prior to fitting to make sure I use the correct spacer?

The last thing I want to do is fit one spacer then find out its the incorrect one and have to take it off!!

Pic below if your interested!

JustcallmeMrT:
I just went through the exact same process.  I read a bunch of posts and the consensus was to use the thin washer, so that's what I did and it fit perfectly.  Hope yours works out as well!

sam_vfr:
Thanks MrT

Did you use the thin washer underneath the bearing on the tripple tree or inside the headset?

Thanks

Sam

mike the bike:
And the washer keeps some of the shite out of the bearing.

sam_vfr:
So would I be correct in saying the washer goes on first, then the dust seal, then the bearing?

Thanks

Sam

Navigation

[0] Message Index

[#] Next page