SOHC.co.uk Forums > Project Board

Dresda Restoration

<< < (4/9) > >>

Bryanj:
Take the primary shaft out and build everything in the top half fitting the primary shaft through AFTER case assembly

masonmart:

--- Quote from: Bryanj on May 17, 2016, 04:40:44 AM ---Take the primary shaft out and build everything in the top half fitting the primary shaft through AFTER case assembly

--- End quote ---

Ow!! The primary shaft is in and it was a very hard job getting it in through the starter clutch, etc., I don't fancy taking it out again but I'll have a look. I followed the manual

Bryanj:
If it was difficult to fit you were doing it wrong they should slide in easy except for a light tap at the very end, this one of few cases where the manual is not exactly right on the easiest way

masonmart:
It's all together and seems OK. Is there a simple way of checking that the gears work?

Bryanj:
Just turn the selector drum BUT you will probably need to turn both shafts at the same time whilst rotating the drum(3 hands required)

Navigation

[0] Message Index

[#] Next page

[*] Previous page