SOHC.co.uk Forums > CB750

CB750 electrics

(1/2) > >>

adriangsmith:
Hi all,
I've just got round to connecting the electrics back up on my 76 cb750f1 following a strip down and rebuild.

Connected up and all working fine until i tried the electric start button.
Headlight was working and neutral and oil light were on.
The solenoid buzzed / clicked and then all power cut out.
Power returned about 20 seconds later but again went when i pressed the starter button again.
Happenened as above twice more and now i have no power at all.
All fuses are OK.
Earth all OK up to handlebars and ignition switch
Still have power to the fuses but nothing further on.
No headlight or idiot lights.

The starter worked fine before the strip down.

Any ideas??

hairygit:
Check the earth lead carefully, did you remove paint/powder coat where the cable attaches to the frame?

Sent from my X5 using Tapatalk

adriangsmith:
Yes powdercoat ground back down to bare metal.
Good earth throughout

hairygit:
Try making a temp earth with a car jump lead from battery earth to a clean bolt on the frame or engine to eliminate a Dodgy earth cable. If that doesn't help, check the plug to the ign switch for power and security, I've known pattern ign switches start to come apart from the lock body and break the circuit.

Sent from my X5 using Tapatalk

AshimotoK0:
Try shorting out the starter solenoid main terminals with a heavy duty cable and see if it turns over then. If it does not suspect earthing or main lead to starter for resistive contact.

Navigation

[0] Message Index

[#] Next page