SOHC.co.uk Forums > CB750

Fuelling or Not ?

(1/2) > >>

Greebo:
Fuelling issue or not ?

Following the re-build of my bike we had to modify the carbs by fitting much larger main jets & raise the needles to the highest point to get it fuelling & running well.

Problem is if I hold the throttle in one position in top gear & cruise at say 60mph constant I notice I bit of hesitation/jerking as though its lacking fuel, if I accelerate past this its not noticeable at all, & if I hold it at slower constant cruising speeds 40 mph it seems OK...

accelerating through the gears it does not miss a beat, its only when holding the throttle in a fixed position as mentioned above.

Any ideas guys on what this maybe  ?

Johnwebley:
could be over rich ?


 do a plug chop at that speed,

check they are not dark and/or sooty,at least you shouldn't need to sweep the pipes clean !!

MarkCR750:
Might be worth re-checking your float heights as well, or even taking them away from the standard setting, it's possible that you are demanding more fuel than the float bowls can supply with the standard float height setting due to the larger jets.
Going the other way , I.e too rich, if you have an air box take the filter out and see what that does on a short ride, it's going to be trial and error due to the changes you've made.

Greebo:

--- Quote from: MarkCR750 on April 20, 2016, 08:19:04 PM ---Might be worth re-checking your float heights as well, or even taking them away from the standard setting, it's possible that you are demanding more fuel than the float bowls can supply with the standard float height setting due to the larger jets.
Going the other way , I.e too rich, if you have an air box take the filter out and see what that does on a short ride, it's going to be trial and error due to the changes you've made.

--- End quote ---

Hi Mark

thanks for the reply, its not running rich I have checked that a few times,iridium plugs are a good colour, no air box fitted using K&N's

I did not know the floats were adjustable, however as mentioned previously when I accelerate past this I don't get a blip at all, I can power through the gears right up to 90mph no problem no blips or hesitation [90mph is the maximum I have done to date]
the problem is when I hold the throttle steady in one position at cruising speed around 60mph. but I have to say it does seem like a fuel issue, but I would have thought if it was fuel I would also get it above this speed when its obviously demanding more fuel.

I will ask the bike builder about the floats

Any other suggestions very welcome

cheers

MarkCR750:
If you google "setting float levels Honda chopper .com" there is an article with photos on setting float heights, as you say it's ok above 60 so maybe it's not float heights, if you hold a steady 70 and then accelerate there's no problem then ?, does it do it if you hold a steady 60 in 4th gear and then accelerate ? , I'm thinking maybe the velocity of the air going through the carbs at a steady 60 doesn't suit the K&N's and doing 60 in 4th puts you at higher revs so higher induction air speed, I've got cheapo Chinese K&N's on mine with 135 main jets and the needles set in the middle, no issues in the 10 miles to the MOT station and back but admittedly that's not a lot of testing .

Navigation

[0] Message Index

[#] Next page