This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Davelu88
1
« on: August 21, 2023, 02:11:17 PM »
3 out of the last 4 bikes have been inspected !!!
2
« on: August 21, 2023, 10:58:54 AM »
I have 2 CB 450s that I am registering, one didn't have a title so I got a dating certificate whereas the other had the title etc .I sent of 2 lots of applications and last week had an inspection for the non titled bike which I expected & today I get another email saying the one with the title needs an inspection as well. What is the point of having a title if the DVLA ignore what its for . Rant over
3
« on: August 04, 2023, 08:31:23 PM »
My 550F is still for sale , look in member sales 
4
« on: July 22, 2023, 09:26:56 PM »
Thanks Bryan 
5
« on: July 22, 2023, 03:16:09 PM »
Hi all , i have registered a few bikes all with a dating cert but i have a CB 450 to reg & i have the US title with it ,am i correct in thinking i do not need a dating cert now . Thanks
6
« on: June 30, 2023, 04:18:29 PM »
No.money gone out yet so I guess I have to wait a bit longer , I just want to get it registered as I do not want to pull.it apart yet in case the DVLA want to inspect it.
7
« on: June 30, 2023, 03:33:17 PM »
Anyone know how long a dating certificate from VJMC is taking nowadays 🤔
8
« on: May 16, 2023, 05:23:19 PM »
Success with the centre stand method , it freed it in no time . Many thanks to all 
9
« on: May 15, 2023, 08:07:54 PM »
Some pics of what I have been doing
10
« on: May 15, 2023, 06:11:21 PM »
I will report back tomorrow 
11
« on: May 15, 2023, 05:49:31 PM »
Many thanks , I havehad on centre stand with back wheel spinning but no joy but will give another go tomorrow, am I right turning the adjustment screw to the rear to feel resistance as tur ing it towards the front just loosens it constantly 😀
12
« on: May 15, 2023, 05:08:25 PM »
Hi all , my 550 F is stalling and lurching forward when put in gear , I have tried to adjust at both ends and turned the adjuster screw till it gets resistance but to no avail . The clutch arm is moving freely and I made sure the little notches lined up , could the plates be stuck as not ridden for a bit while refurb took place . Any help appreciated 🙏
13
« on: April 24, 2023, 08:09:27 PM »
Many thanks Ken
14
« on: April 24, 2023, 06:52:16 PM »
DS do a clamp on ignition bracket for the 750 that's looks .Iike it will fit.
15
« on: April 24, 2023, 06:44:20 PM »
I will have to fab a ignition bracket and a speedo one then powder coat them , I was going to use the honda speedo as I know it's correct speed etc.
|
Show Posts