Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Peterplank

Pages: [1] 2
1
CB500/550 / 500 K1 replacement shocks
« on: July 01, 2026, 06:55:07 AM »
This may have been asked before but...
Any recommendations for decent UK rear shock replacement for 500 ? Seems like Hagon look like the best bet although pricey, wondering if I've missed any others...
Bike great but feels skitty bounces around a bit to easily.
Any suggestions would be helpful.

:o)

2
CB500/550 / Scruffy 500 on FB
« on: June 05, 2026, 03:23:36 PM »
Just seen a scruffy 500 on FB marketplace, Reading UK £1000
if anyone interested 👍👎🏻

https://www.facebook.com/share/1Df17qmWME/

3
CB500/550 / Re: cb 550 k3 carb intake rubber
« on: May 11, 2026, 09:26:04 PM »
I’ve got a couple off 500, used but ok… I think the same ...you can have if you like :o)

4
CB500/550 / Re: 500 fuel pipe too long ?
« on: March 18, 2026, 10:13:34 PM »
Using smooth nitrile fuel pipe, not reinforced..
I did cut to 300 and 180 but was too long.

5
CB500/550 / 500 fuel pipe too long ?
« on: March 18, 2026, 09:50:08 PM »
Carbs fully rebuilt inc new fuel pipes, pleased to say bike started and running nicely.. I did 10 miles and it started to feel lumpy like running out of fuel and just about running..
When I got home and had a look around I noticed one of the fuel pipes looking a bit flat on the bend under fuel tap.
Could it be that pipe ok and staying round when cold but when everything heated up pipe can flatten and starve of fuel if an it's inch or so too long ?
Cut a bit off and started fine but can't try it till tomorrow...
does anyone have experience of this ?
Obvs hope so as a simple fix
:o)

6
CB500/550 / Re: New battery recommendations ?
« on: March 11, 2026, 10:21:30 PM »
Thankyou, Motobatt ordered...
I'll find out if I got the carbs right very soon...

7
CB500/550 / New battery recommendations ?
« on: March 11, 2026, 08:18:25 PM »
Can anyone recommend a decent battery please ?

8
CB500/550 / Re: Brake caliper pivot pin
« on: March 07, 2026, 02:09:36 PM »
Thankyou, about to clean, re grease and fit new o rings 👍
Could have sworn I was only doing the carbs 😆

9
CB500/550 / Brake caliper pivot pin
« on: March 07, 2026, 01:57:57 PM »
Hello all,
Before I start hitting anything...Could anyone tell me if the caliper pivot just knocks apart or screws out ?

 :)

10
CB500/550 / Re: New throttle cables ?
« on: February 18, 2026, 01:55:48 PM »
Thank you  :)

11
CB500/550 / New throttle cables ?
« on: February 18, 2026, 07:09:41 AM »
Good morning all,
Can anybody tell me any good quality 500 K1 throttle cables that are available in the UK ?
There are several around but it's hard to tell which are good.

Carbs back together and fitted after much swearing 😆

12
CB500/550 / Re: Airbox rubber Seal
« on: February 08, 2026, 05:54:50 PM »
Ah ok, that explains it...
Hot soapy water it is then  :)

13
CB500/550 / Airbox rubber Seal
« on: February 08, 2026, 04:16:58 PM »
Hello all,
At the point of putting carbs back on after rebuild and finding more to do of course..

I'm looking for a replacement rubber seal that goes between the 2 black main airbox parts, can anyone point me in the right direction please ?

The main box not the air filter itself

I can't see it on the David Silver or cmsnl drawings...

 :)

14
CB500/550 / Re: Emulsion tubes question
« on: August 16, 2025, 10:46:24 AM »
Thankyou 👍

15
CB500/550 / Emulsion tubes question
« on: August 16, 2025, 08:32:35 AM »
Good morning all..
I'm putting my 500 K1 carbs back together...
Should the emulsion tubes be a snap in tight fit or not very tight ?
My original cleaned ones push in fairly easily and not tight... do they get held in place my main jet o ring and spring once all together ?
 :)


Pages: [1] 2