Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Alexgill2001

Pages: [1]
1
CB500/550 / Air filter rubber seal #17221390300
« on: January 04, 2026, 07:46:08 PM »
Happy new year to everyone. I would like to replace the Air filter rubber seal on my 550K as its getting worse and worse everytime i remove the top. I believe the part number is 17221390300 but I can't find anywhere that stocks it. Has anyone used something else in its place?
Thanks

2
CB500/550 / Re: How to paint the letters on light and kill switch control
« on: November 12, 2025, 06:51:26 AM »
Thank you for the advice so far, looks like I'll have to take it off/apart to get it in the oven! Can I ask, is there any advice to take it apart? Do I have to cut some cables?

Currently I've managed to tape up and cover the whole bike to avoid over spray!

3
CB500/550 / How to paint the letters on light and kill switch control
« on: November 11, 2025, 08:43:17 PM »
Evening all, I have wanted to recolour the red writing on the right hand light and kill switch control. Initially I used acrylic paint and a cotton bud to fill the embossed letters, however when I went to wipe the surface it removed the black paint!! Argh!! 

I then took it all back to bare metal, primed it and then sprayed it black (oil based paint). Used the red acrylic again and it again reacted and removed the black as above (I didn't realised oil and acrylic didn't mix!).

Starred again, bought red from the same company as the black paint (oil based) and yet again after wiping away it removed the black!!

Any one have any tips and/or what paint to use for both the black and red that won't react?

Thanks!

4
New Member Introductions / Re: Re-chroming
« on: October 01, 2025, 10:38:57 PM »
@Bryanj thank you very much for your offer I will keep it in mind! Regards

quote author=Bryanj link=topic=32284.msg313647#msg313647 date=1759333843]
You can buy pattern exhaust cheaper than rechrome, i have 2 used ones in my shed, yours for a donation to charity and carriage not sure which ones
[/quote]

5
New Member Introductions / Re: Re-chroming
« on: October 01, 2025, 08:36:40 PM »
Website looks good, I'll give them a bell in the morning. Thanks very much!

6
New Member Introductions / Re: Re-chroming
« on: October 01, 2025, 04:35:12 PM »
For a CB550 K3. What are the other options then? Must be a way of getting it repaired?  Cheers

7
New Member Introductions / Re-chroming
« on: October 01, 2025, 11:31:24 AM »
Morning all, I need to get my exhausts re-chromed and at least one of them needs some attention with a hole so I assume a bit of cutting out and welding some new material in.
From the research I've done so far it appears most re-chroming services are now in Birmingham. I found a semi local one in Ashford, Kent but they don't deal with exhausts.
Does anyone know a good re-chroming service, pref in the South East if not one they can recommend elsewhere and I guess I'll have to post the items to them. Also do you know if they will repair the exhaust first an/or a recommendation for this service first?
Thanks
Alex

Pages: [1]