Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Wrenchpuller

Pages: [1]
1
CB350/400 / Re: Cam Tensioner Rod, Springs and Bolt
« on: Today at 08:40:31 PM »
Ok ill see if I can get in touch thanks for your advice

2
CB350/400 / Cam Tensioner Rod, Springs and Bolt
« on: Today at 03:38:47 PM »
Hi all,

It appears a previous owner has done a bit of a diy job on the camchain tensioner. The rod has been replaced with a cut bolt and there are no springs. Adjustment was done by a bolt and locknut to push the makeshift rod down manually. And the rod lock bolt doesnt appear to be correct either.

I have one of the new bronze bushed adjusters ready to go in, just wondering what the best course of action would be? I have a spare plug bolt and it looks like you can get the proper rod from DS, I've seen new lock bolts too. But the springs seem to be unobtainiable.

What do we think would be the best way forward? I have took some pictures also.

Thanks, Dylan

3
CB350/400 / Re: Oil passages
« on: July 22, 2026, 09:31:24 PM »
Hello! Thank you very much! I've read the odd bit on this forum since getting a 400 about a month ago, thought id finally make an account! I'll save the rest for the introductions section when I get around to it  ;)

4
CB350/400 / Re: Oil passages
« on: July 22, 2026, 07:12:56 PM »
Ok thanks Julie, never had one of these off before is all and never seen a stepped hole like that

Thanks again

5
CB350/400 / Oil passages
« on: July 22, 2026, 04:58:57 PM »
Hi all,

Currently stripping my engine to do all the seals etc. Just a question on the top oil passage behind the oil filter, is it supposed to look like that?

Picture attached
Many thanks

Pages: [1]