This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Galea
1
« on: June 12, 2012, 12:10:05 PM »
Found NOS piston on auction site. Thanks for your help 
2
« on: June 09, 2012, 06:25:39 PM »
Received the lens from Mick today, a true gentleman
3
« on: June 04, 2012, 10:48:17 PM »
Mystery solved, the case is closed
4
« on: June 04, 2012, 05:50:17 PM »
Thanks Mick, that would be great! PM sent.
5
« on: June 04, 2012, 06:20:58 AM »
Hello Archmill, looks exactly like that one but we will be sure when you check the numbers. I need just the lens, what bike is it on? Do you have a part number? Thanks.
6
« on: June 03, 2012, 07:40:04 PM »
Thanks for your replies, the bike should be a UK one. Frame number is CB750F-1039XXX.
Mick, if you do find yours, could you check the numbers on the lense for me?
Thanks,
Joseph
7
« on: June 03, 2012, 06:11:36 PM »
Close-up
8
« on: June 03, 2012, 06:04:18 PM »
Looking for a tail light for a 1977 CB750F Supersport but the ones I've seen so far are unlike this one. They are either mounted by two screws or else 4 screws near the centre. The one I have is mounted by 4 screws very near the corners and it has the following code: STANLEY RR501 SAEA 71 1ATPE181 1 E 11 3246 AU40L1A JAPAN R-169
Any help, better so with part number, would be greatly appreciated. Thanks in advance.
Regards,
Joseph
9
« on: June 01, 2012, 03:36:09 PM »
Today I adjusted my exhaust valve clearances at 0.004" too. No difference in engine tappet noise to my ears 
10
« on: June 01, 2012, 06:10:45 AM »
Thanks for the link, but its a different part number and piston top is also different with deeper valve recesses.
11
« on: May 31, 2012, 09:03:53 PM »
Thanks for all the suggestions, much appreciated. I am not in a hurry since this is for my 'spare' engine, so maybe its worth waiting until I find a new piston.
12
« on: May 31, 2012, 09:01:15 PM »
I wouldn't
14
« on: May 29, 2012, 10:06:02 AM »
Only need one piston, since the other 3 are good. However, thanks for your reply.
15
« on: May 28, 2012, 10:04:28 PM »
I'm looking for one standard CB750 K7 piston for engine CB750E-300XXXX (marked 392 near gudgeon pin, and measuring approximately 60.9mm at bottom of skirt). I would appreciate any help in locating one, preferably new (long shot, since these seem to be discontinued) or else good used. Thanks in advance.
Regards,
Joseph
|
Show Posts