cb750k1 circlip

[Green1]

What is it with fork seals I hate doing them especially when Iv had to do them on my CG and peg last week and today they have blown on the 750 and 550

Does anyone know the size of the circlip in the front forks on a 750k1?
Mine have passed there best and rusted thin.

[Trigger]

Measure the old one Or 50mm

[Green1]

I could have measured them or even Googled it but I didn't think of that    
 

[Trigger]

Lazy git, that's another pint you owe me

[Green1]

I don't know about lazy I just put more effort in that post then I did googling it.

I have this week of work if you fancy doing it. 

[Trigger]

I don't know about lazy I just put more effort in that post then I did googling it.

I have this week of work if you fancy doing it. 

The last time I had a whole week off, I was 17 years old. You can always give me a hand this week, only 3 x CB750 and a CB500 engines to do 

I can only dream of having a cir clip to fit

[Green1]

You don't want me near an engine it would never be the same again. 
Iv had the gold bike as a rolling frame for the last 4 years 

[mike the bike]

Never mind the gold one, pull your finger out with the 400

[Green1]

The rate I'm going the 400 will be finished in 2030