« previous next »
Pages: [1]   Go Down

Author Topic: 750 F2 engine bars..  (Read 432 times)

Offline Wil

  • Newbie
  • Posts: 6
    • View Profile
750 F2 engine bars..
« on: September 26, 2018, 06:19:12 PM »
Hi..I recently picked up some engine bars for my cb750/F2...but on trying to fit them I realized the 2 engine mounting bolts will be to short in length !!! ..is my easiest solution to just buy some longer threaded bar ? As I don't think bolts etc will work because of channel that mounting rod runs through?.. Any thoughts welcome...regards Wil.
Logged

Offline hairygit

  • SOHC Jedi
  • Posts: 2708
    • View Profile
Re: 750 F2 engine bars..
« Reply #1 on: September 26, 2018, 07:14:54 PM »
Probably, or take an angle grinder and thin the mounting blocks down on the frame( DON'T DO THAT!, only kidding!)
Logged
If it's got tits or wheels, it's hassle, if it's got both, RUN!!!

Offline Wil

  • Newbie
  • Posts: 6
    • View Profile
Re: 750 F2 engine bars..
« Reply #2 on: September 26, 2018, 07:57:26 PM »
Lol...👍
Logged

Offline Trigger

  • Grogu
  • *
  • Posts: 8436
  • Engines built on reputation, not advertising.
    • View Profile
Re: 750 F2 engine bars..
« Reply #3 on: September 26, 2018, 08:20:05 PM »
I would not use threaded bar . After some years the road grit collects in the threaded part and is a nightmare to get the bars back out, if need be.
Any good engineering firm will make you a longer set of mounting bars and bolts  ;)
Logged

Offline Bryanj

  • Grogu
  • *
  • Posts: 10796
    • View Profile
Re: 750 F2 engine bars..
« Reply #4 on: September 27, 2018, 01:14:28 AM »
New ones came with longer bolts and nuts to fit as the thread was different
Logged
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal