Author Topic: CB550 K0 Float Bowl Gaskets (Read 788 times)

GTB981 · « **on:** December 24, 2019, 04:05:48 PM »

Need a set of float bowl gaskets for my CB550K0 after renewing float valves. Where`s the best place ? Thanks, Geoff.

Bryanj · « **Reply #1 on:** December 24, 2019, 04:10:37 PM »

Same as 500, probably cheapest to get O ring kits from Gerben

GTB981 · « **Reply #2 on:** December 24, 2019, 04:11:13 PM »

Cheers, I`ll take a look.

GTB981 · « **Reply #3 on:** December 24, 2019, 04:12:49 PM »

What, as in a kit of O-rings ? when I searched I couldn`t see carb o-ring kits.

Deano400 · « **Reply #4 on:** December 24, 2019, 06:07:00 PM »

GTB981 · « **Reply #5 on:** December 24, 2019, 06:13:02 PM »

I guess so, but only need the float bowl ones.

Seabeowner · « **Reply #6 on:** December 24, 2019, 06:18:45 PM »

I used 68mm x 2mm Viton O rings. They were a tad big, but got them in the groove ok. Came off ebay.

GTB981 · « **Reply #7 on:** December 24, 2019, 06:24:16 PM »

Cheers for the dimensions.

GTB981 · « **Reply #8 on:** December 24, 2019, 06:26:01 PM »

Is 68mm O/D or I/D ?

peterengland · « **Reply #9 on:** December 27, 2019, 03:32:08 PM »

Have had the float bowls off my carbs a few times, never renewed the gaskets and has never leaked, guess I'm lucky ?

deltarider · « **Reply #10 on:** December 27, 2019, 04:43:55 PM »

Same here. The later model bowl helped.

sye · « **Reply #11 on:** December 27, 2019, 05:18:33 PM »

Is 68mm O/D or I/D ?

68mm x 2mm is 68mm I /D x 2mm section, so is 68mm I /D x 72mm O/D.

Honda-SOHC