Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
Sound like you need a new float needle for the one that isn't springing correctly.
Also, the pilot jets could have been incorrectly adjusted because of the air leaks where the clamps were missing. The clamps need to ALL be fitted and tight, otherwise random air leaks will mess with the mixture and you will never get it running smoothly and reliably.Sent from my POT-LX1 using Tapatalk
Quote from: Nurse Julie on April 12, 2020, 11:53:56 AMSound like you need a new float needle for the one that isn't springing correctly.I was worried it may be that - I've removed pin / float black thing and the needle is clean and springing properly So I've slightly adjusted the metal tang bit that touches it and after a little trial and error it now moves and springs like the other three
Quote from: SPR on April 12, 2020, 11:59:54 AMQuote from: Nurse Julie on April 12, 2020, 11:53:56 AMSound like you need a new float needle for the one that isn't springing correctly.I was worried it may be that - I've removed pin / float black thing and the needle is clean and springing properly So I've slightly adjusted the metal tang bit that touches it and after a little trial and error it now moves and springs like the other threeYou probably need to check the float level on all 4 to make sure they're right.
Look in the 550K3 supplement and be careful on the modle as there are 2 different float heights
Thats just deformed in use mate, make sure the tiny washers gonbetween the spring and O ring