Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
Quote from: taysidedragon on November 12, 2020, 11:27:16 AMAll the parts I need for the rebuild have arrived and the gear bush is sorted.Primary drive rubbers and gasket set not in picture. Let the fun begin! 😁 (Attachment Link) Eye candy - lovely what make are the pistons and who did you source them from I'm pretty certain I might end up needing some early next year.?
All the parts I need for the rebuild have arrived and the gear bush is sorted.Primary drive rubbers and gasket set not in picture. Let the fun begin! 😁 (Attachment Link)
it looks impossibly fiddly presumably having to fit two at the same time then the second pair fighting against the weight of the barrels
Hope you can post some pictures and details on fitting the pistons to the barrels. In my mind it looks impossibly fiddly presumably having to fit two at the same time then the second pair fighting against the weight of the barrels unless you have the engine on it's side.It looks as though gudgeon pins just push through the piston & the little ends with a clip on each side or are they an interference fit as well?
Quote from: Laverda Dave on November 12, 2020, 12:01:45 PMAll those parts look reassuringly expensive Don't forget the Hondabond for the case joint!Time to make a cuppa and get started on the adventure Good luck and keep the progress photos coming.Yep. Got a tube of Hondabond HT. Forget to put it in the pic.I haven't added up the cost yet, but got the Kawasaki primary chain from MSP, piston set from Cruzinimageand o-rings etc from Nurse Julie so did quite well on prices. 👍🔧🏍
All those parts look reassuringly expensive Don't forget the Hondabond for the case joint!Time to make a cuppa and get started on the adventure Good luck and keep the progress photos coming.
This all brings back memories of my engine, with the exciting stage of getting it all back together. That was 3 years ago, where have they gone 😢😢😢😢