need a seal part no

[MIKE550/4]

difficult to pin this down in words,

 steve d  you dont happen to have parts list photo for the front spindle do you ,

 best i can explain is where the chrome cover sits speedo side , under that chrome cover there is part which splits into 2, round the part that pushes out is a rubber seal, it looks like a ver small rubber band

550 k3

cheers if you can help

[MIKE550/4]

nearest pic i could find , part 8, the middle section pushes out and there is a seal round the part that comes out, only gives part no for whole item, only need the seal ... anyone ?


http://www.motogrid.com/pages/parts/viewbybrand/parts.aspx

[matthewmosse]

Silvers can normally find these bits over the phone without part numbers, might do the trick. Ps did you get the bearing retainer out in the end?

[SteveD CB500K0]

Don't know if this helps, but...

[MIKE550/4]

Yes its all stipped , have one side of bearing back in , had to chop it out in the end , still  got to do back wheel ,  big learning curve for me this but getting there

[MIKE550/4]

will see if its available seperately cheers

[MIKE550/4]

Well not available from ds, might have to make something

[Bryanj]

The only seal I know of is part of the speedo drive.

[MIKE550/4]

bryan on that part no  8 there is a section that pushes out, round that part there is like a band will try and get a pic up

[MIKE550/4]

can i get away with re using or adapt something else

[SteveD CB500K0]

I don't see why not - there's no oil pressure behind it is there?

[MIKE550/4]

that i am unsure of

[SteveD CB500K0]

That was a rhetorical question Mike...   

There is no pressure - it's just a grease seal for the front wheel.

[MIKE550/4]

 
Oh right steve, will make something to get this sealed up , just got back to change bearings and then wheels can go back on

getting there slowly

[Bryanj]

That speedo drive plate is totaly different to ANYTHING i have seen before!! It ought to be one steel piece or how will it drive the gearbox?