Hi All,
A quick question........................
I ordered a complete seal kit for the Z400J and this included the two crankshaft oil seals.
I fitted the seals and all appeared to be fine, crackshaft turned, the lip was properly in place so I bolted the two crankcase halves together. Skip forward a couple of hours and the tidy up and I noticed the old crankshaft seals had a ridge around the outside of the seal (as do Honda seals) to fit inside a machined groove in the crankcases. The new seals didn't have the ridge.
Question is do you think the new seals are OK? They are from Wemoto and they are a reputable company. The seals are Japan made. I really dont want to take thje engine apart but then again I dont want the new seals to blow under pressure.
What does the forum think....?