Spark plug socket

[totty]

Hi,

Can anyone tell me where I can find a spark plug socket that will fit the middle two plugs?

Cheers

Allan

I've just been reminded how much I hate messing about with points, the scimitar was bad enough till I went electronic but 2 little fiddly sets is even worse.

[matthewmosse]

Lathe and make it fit that way (if the physical size of a sockett you have is the problem), the plug spanner size seems to be a bit difficult to get outside of a sockett set. A good hardware shop should stock then individually though. Plug spanners are sized by thread diameter it seems, the 500 /550's use a 12 mm one.

[mhirst121]

David Silver do a plug spanner.

[totty]

I bought an individual socket but it's too bulky and I don't have a lathe. I'll try silvers.

[matthewmosse]

shame your not closer, I could thin a sockett down easily enough, had to do it for swing arm bearings on my beemers before now.

[Bryanj]

Honda part number 89216-323-000 is the one from the tool kit and best one for the job

[pae]

lot of genuine Honda ones come up on ebay. Not sure what you'll need but I got a CX500 one for only a few quid that fits my 650 fine,

Phil

[totty]

Thanks everyone, I've just bought one off ebay that looks like it should do the job.