Having rechecked everything on the new DSS coils, the primaries are showing 3.4 ohms and the secondaries with new 5k ohm NGK caps are totalling 21.5k ohms (not far off your 24!)
When measuring low resistances, in the 200Ω range, it's good practice, before you start measuring, to firmly hold the probes to each other, to read the internal resistance (see pic below). Usually it's around 0,3-0,4Ω, which means the actual measuring will result in a reading that will indicate a 0,3-0,4Ω higher resistance than it actual
is.
Would those levels cause particular symptoms?
Mwah. The primary resistance is on the low side, which could cause extra pitting at the breaker points, as they switch a higher current. Standard is 4,3 - 4,7Ω. Was DSS open about they're being
not standard? Could you post a link to them?
The bike runs well apart from the occasional hot tickover stalling I’m investigating.
Owners of a CB500/550 should be aware of a typical weak point: the plugcaps. They're weak in two aspects.
1. They're exposed to rain and wind which effects their reliability. As a matter of fact, in the 42 years I own my bike there's been only one occasion, I didn't make it home. In torrential rain, they and/or the HT leads got soaked and the engine died.
2. GND (ground) is often all too close to the HT leads and/or caps. Checking is simple. Have the engine run in the dark and watch closely if you see arching between the plugcap and/or HT lead to the head. When concentrated, you can even hear it spark, which means that the spark you've witnessed, has
not been delivered in the combustion chamber.
Another simple test is to check the condensers are not leaking. Faulty condensers may cause arcing as shown in the vid:
https://www.youtube.com/watch?v=t3cuvGVwnjI At the breakerpoints a bit of sparking is normal, excessive sparking or arcing is not good and can indicate a bad condenser. In this vid the left condensor (1+4) is bad, right condensor (2+3) is good.
Video: courtesy Ulf PennerWhilst you are there, also see to it the forked connectors at the back of the breakerpoints are not accidentely grounding to the plate.
This can be intermittent! Especially the 2+3 breakerpoint has its connectors dangerously close to the crosshead nearby.
BTW, are you familiar with Ohm's law? I have a very simple and practical formula related to your bike, which will make it clear and impossible to forget.