Does anyone know where I could get one made?
I am fitting rearsets on my 750F2 project, and the upper rear engine mounting bolt goes through the F2's chunky alloy footrest hangars and through the footrests themselves. The thing is 12mm diameter, 430mm long, with an M12 x1.25 thread at both ends. Well....as I dont have the footrests on this anymore, my bolt is about 30mm longer than it needs to be, and sticks out quite a bit on both sides. Plus, as there is about 20mm of thread each end, I would need to pop in spacers to tighten it up too. Just looks wrong.
I need to have one 30mm shorter.
At a push, I guess I could buy a spare stock bolt and cut it down...but I would also need to buy the right die to cut the thread, as all mine are metric standard...not metric fine. The bolt is also going to be fairly hard steel...so a decent die would be needed to cut hte thread I need before I chop the bolt down. I am not going to damage ANY of hte original parts that are usable, so the bike can be put back to stock ( or as near as it was when I got it ) at any time.
I am reckoning it may be cheaper to just get one made up