Top line on forum selection go to either "Aladdin's cave" or "Ash's dropbox" for manuals. Should all be there for you.
If difficulty, the routine sets all the screws at baseline about 1 1/2 turns out to start, warm up to get off choke, then same routine for each carb successively, turn the screw very slowly outward and as revs rise it should start to just falter in firing that cylinder (it's the beginning of running too lean at this point) then concisely turn the screw back inward to drop the revs by 100 rpm (this sets it at optimum for the fuel in use on that cylinder, and with just enough richness) then adjust overall tickover with master idle control to reasonable level and work through each successive cylinder until all all four are completed.
The screws may end in slightly different places one to another, but should be reasonably close. This correct and not a blanket turns out setting for all cylinder.