General > Announcements

400/4 fuelTap Filter .

<< < (2/4) > >>

THUNDERDOWNUNDER:
I have a new kit but the rubber seal has got lost . I did ask Julie but she says no .

McCabe-Thiele (Ted):
Can you not measure the old seal or has it been binned?

THUNDERDOWNUNDER:
Yes still have the old one but it’s very fragile . I think the size is 16 mm x 1,5mm x10 mm . The 10mm is the hole size .

McCabe-Thiele (Ted):
Your sizes don't really add up but try some options here for size.
If they are 1.5mm wall thickness rings with an inside diameter of 10mm then the outside diameter would be 13mm.
If they are 1.5mm diameter with an outside diameter of 16mm then the inside diameter would be 13mm.

The ring shown in your diagram as 16mm o/d with 10mm i/d would be a 3mm thickness ring - this size is listed if you enter the details

I think the 16mm * 1.5 is the thread pitch.

https://www.polymax.co.uk/o-rings/rubber-viton-oring/

Johnny4428:
Yes the plastic on my mine had whole in it. Best to replace with kit if your filter is looking a bit old. Also old one could be compressed?  Hence 1.5mm.

Navigation

[0] Message Index

[#] Next page

[*] Previous page