Points cable clips (cramper!)

[Matt_Harrington]

I'm missing the cable clips for my points cable. Anyone got the pair (to sell) that go on the engine OR an outline of them so I can fabricate a couple?
I think the parts used to be: 32117-371-000 & 32112-333-000

[Laverdaroo]

Got a piccy Matt, cant find any images on line and I might have something in my  parts drawers that came off during the strip down......

[Matt_Harrington]

The one near to the points cover is different but this is the one further up. I haven't got a picture of the other  :'(
[ Guests cannot view attachments ]

[Matt_Harrington]

And this, I think is the other clip....
[ Guests cannot view attachments ]

[McCabe-Thiele (Ted)]

If you fail to find something suitable most trade electrical sellers have stuff like this - there are wider & longer  ones that you can drill out.
I would have thought other models would have something that works - my old lawn mower had something similar.

https://www.ebay.co.uk/itm/134570778114?hash=item1f550b1e02:g:NRAAAOSw~T9jvX33&amdata=enc%3AAQAIAAAA4NpcCWEnWdZWpH6cgSFdxVQNLQeWoyCPoSPQL9WgwvjVwpaG6EgbbRf52WgFZZGcrbv8c80ktFjrxLsUrad0%2FEdGhrfczCupjXPgnzSKUKUxqU3EWejRyUuczXXJBfpvgqfJoHF8bp7T1v%2F1gb0MJW2VVM3dMg6G9ptsM393jVS52VUE4sPJze6ESmUZMx%2F5%2BEGFqi5hxfKHDkNARhyAEmUkq4u9ZuA5TN2w8Osg2GkhqozzLT3ncJz68achh6PExNhS5JeCA0apatWGuv0jii5cJVj5jPtFi8FmgT37GsLn%7Ctkp%3ABk9SR_aJ6fGDYg

[Bryanj]

Try looking at 32111323000
They have a plastic coating to protect cable.
Should be available from any Honda dealer but about £4 each

[Laverdaroo]

Matt I just cut some from some galv sheet, prepped and painted them and bobbed a bit of shrink tube over the top to protect the wire. Cost pence and you can’t tell the difference unless you were looking out for it…..


Sent from my iPhone using Tapatalk

[Matt_Harrington]

Roo, that is what I was thinking of. However, you know me and the stainless sheet will be coming out!! 
Just realised that there maybe the clips on the engine from Tim, will look a bit later.....

[Laverdaroo]

That’s a good shout…..I’m sure there’ll be some to poach off that…..

I didn’t have any stainless and only galv guttering that I cut up

Works a treat


Sent from my iPhone using Tapatalk

[sye]

Rubber lined stainless P-clips?

[Laverdaroo]

No there like a flat tang which the bolt goes through and then you bend to suit over the cable.


Sent from my iPhone using Tapatalk

[Oddjob]

I'm making some out of a sheet of stainless steel, cut to shape, round the ends off after punching the 6mm hole through then using some glue lined shrink wrap tubing to line the steel. I made one the other day for a fuel pipe clip on a bank of carbs, turned out rather well considering it was a first attempt.