Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
All mine just fell off Dom. Try some heat and see if that helps. I have a few of the shafts if you bugger it up.
Yesterday I travelled to Bryan to pick up my .5mm rebored barrels, I assembled the bottom end when I got back using what I thought was the thinnest layer of Hondabond, maybe it was due to my garage being pretty cold but it was near impossible to brush on. I ended up dabbing it on with my finger to get a thin covering. When I torqued all bolts down I got a small amount of sealant squeeze out which is now concerning me, in my haste, ok it was excitement, I missed to hondabond the two crank end seals. Do I need to split it an do it all again?
I would pop some grease on those stud threads Dom.
Quote from: McCabe-Thiele (Ted) on October 25, 2023, 09:06:00 PMI would pop some grease on those stud threads Dom.Bryan suggested I didn't put anything on the threads as it mucks with torque settings. Might have a bit of a hold up with my barrels now though.