Other Stuff > Desperately Seeking!!

550 barrels

(1/9) > >>

DomP:
I may be needing a new set of barrels that I can get bored out to 0.5 oversize if anyone has a set in good condition?

Oddjob:
Thought Bryan had done some for you?

Bryanj:
The liners were the hardest i have ever come across Ken and it rippled a bit at the bottom which i didnt notice, i think they might be ok at next size but Dom would like to stay at 0.5.
Ive said i will sort it no matter what for him

Oddjob:
Dom sent me some pics Bry and TBH it looks like they didn't clear at 0.5mm, there are black areas and they should all look uniform grey.

I suggested fitting some spare liners in the bad cylinders, I have a couple spare. Then get those rebored to suit. What do you think?

DomP:
It was only when I ran my finger around them with some oil that I fet the ripples, if you have then available Ken and Bryan is happy to bore them out to .5 oversize.  I could get these two out and shrink the replacements in before posting them back to Bryan (that journey to Gloucester is going to get me a speeding ticket if I do it much more, narrowly escaped a van on the way in last time)

Navigation

[0] Message Index

[#] Next page