Hi, I have just started to place the wiring loom in place and done some continuity tests and found I am getting earth readings from the black wires? the only switches that are attached are from the front end, ie lights, indicators ignition switch. I cant see from the wiring diagram that this should happen, but may be wrong? green wires also show to earth. I also get a lower reading from the yellow wires from the alternator/rectifier when connected together (from earth).
I could check each wire through, but hope this may be normal?
I have also bought a second hand regulator and think that the top cap had been put on the wrong way round with the green, white and black label on the opposite side to the three connectors? I have changed the cap round so that the green lines up with the `E` tab, white in the middle (wont change anyway) `F` tab, and the black to the tab with no marking which I believe to be for the correct wiring of the unit?
Any help would be appreciated
Many thanks
John