Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
A torque bar will not stop you rounding off nut's and bolt's. It will only stop you over tightening them and shearing them off. When replacing bolt's always apply copper grease, but NOT to internal engine parts.
Thanks for all the help so far, interesting info regarding grease, also, I'm thinking about getting Halfords Pro Torque wrench 8-60 Nm seems to cover all the range on my bike.Is this tool any good? at £74.99 should be OK I hope.http://www.halfords.com/webapp/wcs/stores/servlet/ProductDisplay?storeId=10001&langId=-1&productId=178843&catalogId=10151Any recommendation in up to £100 price range?
Do you have replacement tapper screws Bomber? If not I'll throw a couple in with the seat.
Mike, I did send bomber a PM explaining everything he was getting in a bit of a mess. bomber, once you get your rocker off, check all your tappets for any chips. If you find any that are chipped, check all the valves for any damage.