Top yoke D Washers

[philward]

I know these D washers have been discussed on several posts before but has no one made any from dimensions off the originals? I was just going to order 2 from DS but £6 each! (so £15 posted in total). I made some up from washers for the later yokes I had on to accomadate the repo clocks, but now that I have got the original rhino horn top yoke on, don't want to risk a yoke breakage.
Anybody got any or dimensions?
Phil

[Trigger]

I know these D washers have been discussed on several posts before but has no one made any from dimensions off the originals? I was just going to order 2 from DS but £6 each! (so £15 posted in total). I made some up from washers for the later yokes I had on to accomadate the repo clocks, but now that I have got the original rhino horn top yoke on, don't want to risk a yoke breakage.
Anybody got any or dimensions?
Phil

Here you go : 16mm OD, 8mm ID, 2.3mm thick and the cut away is to 14mm 

[philward]

Cheers Graham - l'll have go at making a pair

[Trigger]

Cheers Graham - l'll have go at making a pair

Made a few in my time 
The last one's were made from manifold spacers at ID 8.5, OD 15.5 and 3mm thick. Took them down to 2.4 mm but, you may find some better size ones with a look about.

[AshimotoK0]

I just measured one that's been stripped of its original coating and it measures 2.3 mm thick

[Trigger]

I just measured one that's been stripped of its original coating and it measures 2.3 mm thick

Did say 2.3mm originally Ash but, the last ones I did were at 2.4mm to be on the safe side

[Bryanj]

Come on you two, arguing over 4thou

[Trigger]

Come on you two, arguing over 4thou

4 thou is a mile in engineering these days 

[csd4t]

Come on you two, arguing over 4thou

4 thou is a mile in engineering these days 

And there's millions of them thou's in an inch

[philward]

That's exactly what I've just ordered!

[Bryanj]

Come on you two, arguing over 4thou

4 thou is a mile in engineering these days 

Not on a 70's Triumph it aint!!!