This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - 4wDaz
76
« on: June 26, 2021, 03:20:32 PM »
More the point you need matching weights not sizes
Ok Thanks, the current Con rods are all the same weight C, plus the spare Con rod I have is also a C. Would it have left the factory with different size rods but the same weights ?
77
« on: June 25, 2021, 08:35:33 PM »
Ive read your posts with interest as Im just measuring up to order new bearings, unfortunately no markings are legible on the crank only on the rods, 3 number 2 and a 3. I do have a spare number 2 from another engine so I was thinking I could make a matching set if required
78
« on: June 25, 2021, 05:25:45 PM »
Would an engine come from the factory with all the same size conrods ? for example 4 no 2s ? or is it acceptable to mix them if the weights are the same ?
79
« on: May 24, 2021, 10:31:11 AM »
The 1.9 fl oz Honda Bond lasts Graham for about 10 sets of engine cases.
Do you use Hondabond 4 or HT Julie ?
80
« on: May 15, 2021, 07:10:41 PM »
Yeah that makes sense
81
« on: May 15, 2021, 06:10:22 PM »
I’ve stripped the 400 engine down today ready for the rebuild, I’m a bit concerned about the amount of end float on the crankshaft, the car engines I’ve done in the past had thrust washes on the crank to eliminate this but the Honda engine has nothing. There is no noticeable wear on the crank or the casings but when the crank is pulled from side to side by the stator rotor there’s movement and a definite clunk, the points plate was removed when I tried this, any ideas ? Thanks
82
« on: May 15, 2021, 05:45:48 PM »
Ok thanks ill mention it, he comes highly recommended, he does all the rebores for a mate of mine who repairs and restores vintage bikes for a living 
83
« on: May 13, 2021, 02:12:19 PM »
Thank you
84
« on: May 13, 2021, 10:43:54 AM »
After a long delay I'm ready to have the rebore done, the engineer has asked me to provide the standard bore size (51mm, 2.0079) and the Cruzinimage piston clearance ? I remember reading a post by Julie which said what Cruzinimage piston clearance was but I can't find it now. Thanks
85
« on: November 24, 2020, 07:42:26 PM »
Thanks, ill give them a go
86
« on: November 23, 2020, 11:14:35 PM »
If you really want to push the boat out, there is a set of plus 50's on Ebay, genuine unused Honda parts, includes rings, gudgeon pins and circlips. But, you might want to take out a mortgage, £300.
No thanks 
87
« on: November 23, 2020, 11:13:50 PM »
Cruzinimage do excellent piston / ring kits.
Just had a look at there web site, have you used them before ?
88
« on: November 23, 2020, 05:18:50 PM »
Hi does anyone have a recommendation for new pistons ? My engine needs a rebuild and a rebore, I’ve looked at Silvers website but is there anything better available ? Thanks
89
« on: June 14, 2020, 06:02:40 PM »
Mine are 10 x 1.25
90
« on: May 31, 2020, 10:52:29 PM »
|
Show Posts
