1
Project Board / Re: Mike's CB550 Project
« Last post by Mike_Berkshire on Today at 09:12:12 PM »Whilst I’m working on the forks I’m thinking ahead; optimistically, about putting the front end back together again. I’m going to stick with old school bearings following the comments. I’m assuming I need to remove the lower bearing cup/ race from the the stem on the lower triple tree as it will be worn. Looking at it there is a rubber washer (maybe 2?) beneath it and a shim beneath that. I guess these are removed by levering/bashing from beneath using a drift or cold chisel and then the new one needs a new shim and rubber washer(s). Does this sound like the right approach?