SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Nurse Julie:
Trig says drill it or put a tap down it and try and pull it out.
Underdog1:
--- Quote from: Nurse Julie on August 10, 2018, 09:19:59 PM ---Trig says drill it or put a tap down it and try and pull it out.
--- End quote ---
Did consider drilling it but wasn’t sure if there was anything else to try first. Is the roll pin likely to be reusable after it’s been drilled?
Nurse Julie:
No, there won't be much left of it. They are not available OEM anymore but I know Trig has a big trade pack of them in the engine building workshop.
hairygit:
Why put ANY gasket sealer anywhere other than the top to bottom crankcase joint? a smear of grease on the gasket, then if it needs to come apart again it wont trash the gasket, Honda recommend fitting them with NO sealant.
Nurse Julie:
I bet Hondaman was responsible for the gaskets being flubbered, I think he says use gasket sealer.........😭😭😭
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version