« previous next »
Pages: [1]   Go Down

Author Topic: Dynatek leads and stock plug caps  (Read 2579 times)

Offline gordo

  • Newbie
  • Posts: 38
    • View Profile
Dynatek leads and stock plug caps
« on: December 20, 2016, 03:45:26 PM »
Hi guys dumb question time. Fitting  5 ohm dynatek coils and dynatek leads which have plug caps pre formed, any need to cut pre formed caps off and fit ngk 5 ohm caps?
Cheers gordon
Logged

Offline mike the bike

  • SOHC Jedi
  • Posts: 2652
  • CB400F, Royal Enfield Interceptor.
    • View Profile
Re: Dynatek leads and stock plug caps
« Reply #1 on: December 20, 2016, 05:22:37 PM »
Up to you.  I've got Dyna 5ohm coils and use the NGK HT caps.
Logged
Where's that 10mm socket got to?

Offline JustcallmeMrT

  • SOHC Pro
  • Posts: 532
    • View Profile
Re: Dynatek leads and stock plug caps
« Reply #2 on: December 20, 2016, 06:02:11 PM »
I used the dynatek caps.

Sent from my SM-N9005 using Tapatalk

Logged

Offline gordo

  • Newbie
  • Posts: 38
    • View Profile
Re: Dynatek leads and stock plug caps
« Reply #3 on: December 20, 2016, 06:07:16 PM »
Cheers guys just wanted to check as have a set of caps if need. Will run the dyna caps and see.
Logged

Offline deltarider

  • SOHC Master
  • Posts: 1573
  • My kingdom for a turkey!
    • View Profile
Re: Dynatek leads and stock plug caps
« Reply #4 on: December 20, 2016, 06:20:33 PM »
But you need resistors, either in the caps or in the plugs ("R"), so check if your Dynatek leads/caps have built in resistors.
Logged
Pages: [1]   Go Up
« previous next »