SOHC.co.uk Forums > CB750
K0 Master cylinder problem
Bryanj:
I use two strands of copper multistrand flex twisted together
RGP750:
Thanks all.
I tried the copper wire trick, no luck, pulled a bristle out of a wire brush, still no luck .
I found a .6mm drill and i have a pin chuck so going to strip out the new plunger etc, When i can get the
blooming circlip out.
I have bought a new repair kit. Drill out the hole and have another go.
Report back later.
Cheers
Niko:
I'm just having the same problem. Fitted the rebuild kit last night.
Can someone tell me what the two holes in the master cylinder reservoir do please. I can see the piston move through one....but not the other.
Sent from my iPad using Tapatalk
RGP750:
The hole nearest the lever is quite large but the one nearest the banjo is VERY small you will need a magnifying glass to see it well.
This hole seems prone to blocking if it is an old master cylinder and corroded.
I propose to drill mine out this weekend.
Niko:
--- Quote from: RGP750 on March 03, 2017, 09:00:29 PM ---The hole nearest the lever is quite large but the one nearest the banjo is VERY small you will need a magnifying glass to see it well.
This hole seems prone to blocking if it is an old master cylinder and corroded.
I propose to drill mine out this weekend.
--- End quote ---
Cheers....I boiled mine when I disassembled it....so hopefully it will poke thru?
Sent from my iPad using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version