SOHC.co.uk Forums > CB750
K0 Master cylinder problem
Nurse Julie:
Is that the one Trig stripped down for you 2 years ago Rich?. If it is, it's taken you long enough to realise the hole is blocked ;D ;D Mind you, at least you haven't lost it which is a major result!!! Xxx
RGP750:
Re building is a learning curve for the first major re build i'm sure you know Julie.
Did Trig leave it blocked to see if i noticed then ????? ;) ;D ;D ;D
Nurse Julie:
Hehe, yes, I'm sure I saw him plug the hole just in case you lost something down it ;D ;D I wouldn't know where to start with a master cylinder rebuild Rich, luckily I have never had to do more than top them up with oil, luck I suppose.
Trigger:
--- Quote from: RGP750 on March 02, 2017, 08:47:14 PM ---Re building is a learning curve for the first major re build i'm sure you know Julie.
Did Trig leave it blocked to see if i noticed then ????? ;) ;D ;D ;D
--- End quote ---
I can remember advising you when I stripped both the master cylinders to check the holes ;D
philward:
I used a 1mm and everything has been fine with braking after about 800 miles. Like you said Rich, I couldn't shift the crud without drilling it out - I think I used a small adjustable collet tap wrench (with tin foil wrapped around the drill bit to get the grip) then turned it by hand. But using a small variable speed drill should be ok in my opinion
Sent from my MotoG3 using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version