SOHC.co.uk Forums > Project Board
750 K1 project
Crispy:
Thanks guys...fitted it is then 👍
Crispy:
I'm about to fit the cases together...got new o ring on the gallery feed to front of cases and 2 locating dowels in place on 1 on each side, new primary chain tensioner in,loctited and torqued..all surfaces cleaned, using Honda bond....any advice ..tips...warnings before I go for it? :-\
Nurse Julie:
Maybe a dry run first, just to check it is all going to go together ok.
Trigger:
--- Quote from: Crispy on July 22, 2018, 03:28:52 PM ---I'm about to fit the cases together...got new o ring on the gallery feed to front of cases and 2 locating dowels in place on 1 on each side, new primary chain tensioner in,loctited and torqued..all surfaces cleaned, using Honda bond....any advice ..tips...warnings before I go for it? :-\
--- End quote ---
You need to put the crank seal on first ;)
And final drive seal ;) I will keep looking ;D ;D
Crispy:
Great...good job I asked! Thanks 👍.....I need to get out of the garage for a while tho..I used lacquer thinners to clean all the surfaces..I'm getting a bit high! 😂
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version