SOHC.co.uk Forums > Project Board
750 K1 project
Trigger:
Can't see if you have the roll pin fitted and are all the half rings in ?
Have you done a dry run, to make sure all gears select .
Crispy:
Yes..I have the three half rings and the roll pin that holds the kickstart shaft...crank seal and final drive oil seals are in now...trial fitting ok ..but I'll do it again and try the gear shift this time! 🙄
Crispy:
Woohoo!....I can get 5 gears 😀
Nurse Julie:
--- Quote from: Crispy on July 22, 2018, 04:59:58 PM ---Woohoo!....I can get 5 gears 😀
--- End quote ---
👍👍👍👍👍
Crispy:
Bottom half back together, with Julie & Triggers timely help and advice, 🙌 thanks so much...having the knowledge of you guys available is so invaluable...got to get the top end sorted now but I'm pleased to get this bit done before I forgot where everything went! 💪
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version