General > Out & About

OUT AND ABOUT 2018

<< < (44/80) > >>

Laverda Dave:
Here you Nigel. The plug is a NGK DR8ES as detailed within the Haynes Manual and bought new.
Just going back into the garage to finish the strip down and initial assessment of the damage. Looking at the bits of piston in the sump it appears as though the gearbox has mashed a lot of the shrapnel into powder!
Thanks for the tip Julie. I may require his services!
At least the flypast took my mind off the carnage  :-\

sye:
The holed piston may be as a result of too lean a mixture or detonation (pre ignition). Check plug colour, timing and mixture are correct when rebuilt.

Laverda Dave:
Sorry, I forgot to add the photo of the plug. Here goes.
The crankshaft small end bearing is beyond repair so it's refurb crankshaft if possible. Thanks for the tip Julie. I will add any progress details to my previous rebuild thread and not hijack this one!

Trigger:
Can i see a pic of the other piston. What is a little strange is, the holed piston is very clean of any carbon deposits.

Bryanj:
That plug looks very light gray (weak) to me

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version