SOHC.co.uk Forums > CB750
F2 tank with K6 carbs, problem
Trigger:
Did have a look at a few taps with vac on them and dug some old ones out to find that the vac housing sticks out too far.
The thread I am dealing with is M16 x 1.5.
K2-K6:
The vac on this one is pretty small and looks well within the outlet stub in your original picture, so from that aspect looks possible.
I'll keep an eye on here to see if you solve it before I get to look at this one. I'm working on it next week so if more spec's are needed then I'll post them for you.
Nigel.
neat street:
Could you make a short `elbow` extension? just a thought?
Trigger:
--- Quote from: K2-K6 on June 02, 2018, 10:50:28 PM ---The vac on this one is pretty small and looks well within the outlet stub in your original picture, so from that aspect looks possible.
I'll keep an eye on here to see if you solve it before I get to look at this one. I'm working on it next week so if more spec's are needed then I'll post them for you.
Nigel.
--- End quote ---
Cheers Nigel, did have a look about for a CBX tap, not ready availably on those. Got it sorted just by turning the tap round a quarter so, the tap lever is facing backwards and the outlet is now at the rear. Not perfect but, it will do.
Green1:
I was going to suggest just turning the tap but thought you would just laugh at my simple but rather crappy solution. ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version