SOHC.co.uk Forums > CB350/400
Carburettor Insulators
taysidedragon:
Julie, that's a good theory, but the engine breather hose goes over the top of the carbs, in the frame clip under the frame tube alongside the wiring harness, down behind the plastic air box and joins the contraption under the air filter.
The routing is shown on p87 of the dealer manual. I guess this keeps the rubber hose away from the engine heat as much as possible.
Nurse Julie:
--- Quote from: taysidedragon on October 25, 2018, 03:24:57 PM ---Julie, that's a good theory, but the engine breather hose goes over the top of the carbs, in the frame clip under the frame tube alongside the wiring harness, down behind the plastic air box and joins the contraption under the air filter.
The routing is shown on p87 of the dealer manual. I guess this keeps the rubber hose away from the engine heat as much as possible.
--- End quote ---
Do you know something, that's bloody amazing and yes, I can see it on page 87. My old 400/4 and this one has it routed between the carbs, I will have to re route it but the angle at the bottom before it goes into the air box bit, would be so acute, I would worry it would clamp itself off.
Edit...does anyone know if the original factory fitted breather pipe had bends shaped in to it?
paul G:
See attached ;)
Nurse Julie:
--- Quote from: paul G on October 25, 2018, 03:51:45 PM ---See attached ;)
--- End quote ---
That's what I have been looking at Paul in my manual, what route does yours take?
paul G:
--- Quote from: Nurse Julie on October 25, 2018, 04:09:04 PM ---
--- Quote from: paul G on October 25, 2018, 03:51:45 PM ---See attached ;)
--- End quote ---
That's what I have been looking at Paul in my manual, what route does yours take?
--- End quote ---
The one above in the manual :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version