SOHC.co.uk Forums > CB750

K6 Swingarm Pivot Rod

(1/2) > >>

Johnnyboy750:
Hi all,

Hopefully one of you very knowledgeable types can assist me on this new problem??

I have a K6 750 which I've had the frame powder coated. Ive fitted new bronze bushes which have flanges which were same size as the ones that came out. I also scraped back to metal where the flanges sit so not riding high on powdercoat Once I inserted the pivot shaft I noticed that the pivot shaft does not protrude from either side of the new bushes slightly so that when the dust caps are fitted and its all tightened up in the frame it binds. It was like this when it came apart and as far as I can see its missing no parts so can only presume the shaft is slightly too short?

Has anyone any idea what length this shaft should be, and if I need to buy a new one where from as CMS out of stock and cannot see on DSS?

Also don't want to buy a new one if its just the same as the one I have?

Any assistance would be much appreciated.
Thanks,
John.

Green1:
If you fit bronze bushes you leave the dust caps out.

Trigger:

--- Quote from: Green1 on March 08, 2019, 08:07:00 PM ---If you fit bronze bushes you leave the dust caps out.

--- End quote ---

No, you fit with the dust caps on  ;)

Green1:
My bad just checked mine and there in there.
Why I thought you left them out I don't know  ::)

Bryanj:
I got a 500 four one on the floor but only a tape measure to measure it with, will do that if you want.

Navigation

[0] Message Index

[#] Next page