SOHC.co.uk Forums > CB750
341 repo exhaust fitting issues.
Davelu88:
I would never buy a set of exhausts from Silvers again as the ones for my 550 K1 where the sealing ring joins the 2 pipes together the welds made the joining pipe too short, when this was pointed out to DSS i got the runaround, i eventually made them work with a bit of ingenuity but i would look elsewhere first next time. ;D
Mr_Sheene:
Is this problem exclusive to DSS? I have just bought a set of 300 pipes from DSS but they're made by Yamiya. I've bought them long before I need them, as I had the cash and fear the exchange rate going bonkers in the near future. Plans to reunite engine and frame have gone awry, so they haven't been checked yet.
paul G:
I have just purchased a set for a CB750 K1 from Silvers via Yamiya and the fit was bang on ;D
philward:
--- Quote from: adespin on May 09, 2019, 09:53:11 AM ---You are not alone with this problem, here is my experience with David Silver exhausts. http://www.sohc.co.uk/index.php/topic,16403.msg137927.html#msg137927
Eventually got a set from CMS, they did fit with some forcing but i am not happy with the down pipe bend.
--- End quote ---
I had a similar experience with the CMSL set for my K2 - did fit with some effort in the end
Aspro:
I had the same problem with a set I bought for my K2 from DS, they went back and were returned with the advice they now fitted however they were still a struggle.
I was looking at the headers on the pipes last week and spotted bubbling on the chrome. Informed DS and they offered a full refund when returned, where do I now buy a set with confidence.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version