SOHC.co.uk Forums > CB350/400
Roger’s 400 build
Rogerxlixi:
--- Quote from: waffey on April 29, 2020, 08:41:06 PM ---thanks for the reply, quick question, do the 90 degree spokes fit from the inside of the hub out?
--- End quote ---
The ones with less angle go on the inside. The ones with greater angle go on the outside.
Bryanj:
Its not just the angle but the length from bend to head, if you try one in a holeit should be obvious as one way wont bend round enough to match up with rim hole.
Hope that makes sense
Andych:
--- Quote from: SeanFD on April 29, 2020, 12:47:11 PM ---
--- Quote from: Andych on April 15, 2020, 11:30:34 PM ---Wow... the Cerakote looks really good.. In Australia it would probably be too expensive a process to use on a frame.. the hubs etc all came out really good and will benefit from the Cerakote.
--- End quote ---
Were the pics the right way up down there? On my screen they were upside-down! ;D
--- End quote ---
Strangely they were upside down here as well.. :)
Rogerxlixi:
Another few steps forward over the last few weeks.
Rear wheel fitted, torque arm and rear brake linkage.
New fork tubes to replace the pitted originals. Polished the fork bottoms. Then rebuilt forks with new seals and retainers.
Mounted front caliper, bracket etc.
Had a bit of an issue with the front wheel. The speedo drive was rubbing on the hub and binding up once the axle was tightened up. Ended up spacing the speedo drive, adding a shim on the axle between the drive and right hand bearing.
Nurse Julie:
Sounds like you are making good progress.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version