SOHC.co.uk Forums > CB750

Top yoke washers.

<< < (3/3)

Johnny4428:
It’s M8 Bolt’s and the previous owner tried the top yoke with no washers. You can guess the result of that.😡

AshimotoK0:

--- Quote from: Trigger on October 16, 2020, 05:19:17 PM ---Don't believe everything you read Ash and how do you know that it still has a early K2 yoke fitted  ;)

--- End quote ---

'Cos I am a  psychic and it was an 8mm bolt   ;D ;D

Seabeowner:
I used a couple of washers that that were for the crankcase main bearings off a 500 and cut the edge off as a temporary measure. They are about 2.4mm thick. Can't remember head washers may be the same.

Johnny4428:
Thanks Phil, I will be raking through boxes of bits and pieces over the weekend.

Navigation

[0] Message Index

[*] Previous page