SOHC.co.uk Forums > CB500/550

CB550 F2 Vin Plate

<< < (2/3) > >>

McCabe-Thiele (Ted):

--- Quote from: Bryanj on February 07, 2021, 11:40:00 AM ---Thats the number described as "screw, rivet 15x5"

--- End quote ---

Is the 400/four held on with the same rivets ?

Sesman:
Perfect, thanks for that.

 :)

Bryanj:
As far as i know all the plate rivets are the same. A hint is to carefully drill the head off and not try to drill out thr "pin" as you will probably get an oversize hole

Sesman:
Thanks all. Vin is off. Drexel grinder, paint stripper heat gun and cheese wire did the trick.

Next, s/arm bushes. Though to be fair they look just fine..with very little if any fore/aft and side play. Looks,like the po was a dab hand with the grease gun...what to do?

Bryanj:
Check the collar, they wear more than the bushes, cost a shitload more as well

Navigation

[0] Message Index

[#] Next page

[*] Previous page