SOHC.co.uk Forums > CB750
Wiring on K0
Seamus:
Thats a bit off. Especially being sold as genuine part.
I also recognise the "special tool" as I also have a teenage daughter. These things have to be pink now or they won't fit the bill ;)
Are you looking for the transparent sleeves that fit over the bullet connectors?
Spitfire:
I cleaned up all the connectors on the F1, using WD40, and a very small wheel in my Dremel, then used dielectric grease on them. I bought some new connectors which look just like the originals from eBay, place called Yambits. But I have noticed since I bought them that their prices have steadily gone up, however they are a great match for the originals. Here's a good offer
http://cgi.ebay.co.uk/YAMAHA-RD250-RD350-RD-250-350-WIRING-TERMINALS_W0QQitemZ220533947221QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item3358d8fb55
Cheers
Den
AshimotoK0:
Yes just the sleeve.
The Babyliss straighteners get far too hot and the other temperature controlled ones we have are kn*ckered so I am going to adapt the elements from the kn*ckered one onto a temperature controller and try that (I run a small electronics design and manufacture business so I have plenty of parts). will post my findings.
I am setting myself a weekly targets on the K0 and this week's target is to refurb the wiring loom without spending a hundred quid!!
AshimotoK0:
--- Quote from: Spitfire on January 31, 2010, 12:07:12 PM ---I cleaned up all the connectors on the F1, using WD40, and a very small wheel in my Dremel, then used dielectric grease on them. I bought some new connectors which look just like the originals from eBay, place called Yambits. But I have noticed since I bought them that their prices have steadily gone up, however they are a great match for the originals. Here's a good offer
http://cgi.ebay.co.uk/YAMAHA-RD250-RD350-RD-250-350-WIRING-TERMINALS_W0QQitemZ220533947221QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item3358d8fb55
Cheers
Den
--- End quote ---
Cheers Den- I Have found these from quite a few places but I want to recreate the hot fused sleeves used on early Hondas
Seamus:
Would it be worth emailing these suppliers to see if they would just sell the sleeving?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version